Audio Converter

The Audio Converter turns an audio file into WAV — and, when your browser supports it, WebM/Opus or OGG/Opus. MP3, AAC, FLAC and WMA cannot be created by any browser, so they are not offered. Everything runs in your browser and nothing is uploaded.

Free online tool · Converters · No installation · No sign-up required

Worked example

A 12-minute phone voice memo turned into WAV for a radio editor

A reporter in Manila records a 12-minute interview on a phone. The memo is an M4A/AAC file of about 11 MB. The station editor wants an uncompressed WAV and will do the editing himself.

  1. Load the file. At 12 minutes it is past the 10-minute warning threshold, so the page warns about length, and it stays well inside the 30-minute and 80 MB hard limits.
  2. The browser decodes the AAC into raw PCM with the Web Audio API. Nothing is uploaded, and the decoded audio lives in the tab memory for the rest of the conversion.
  3. Choose WAV. The page writes a real 16-bit PCM file in chunks and reports genuine encoding progress, which does not run at playback speed.
  4. Check the size before sending: the estimate is sample rate x channels x 2 bytes x seconds. A 44.1 kHz mono memo of 720 seconds is 44,100 x 1 x 2 x 720 = 63,504,000 bytes, about 60.6 MiB. A 48 kHz stereo recording of the same length is 48,000 x 2 x 2 x 720 = 138,240,000 bytes, about 131.8 MiB.
  5. For comparison, the same clip as WebM or OGG Opus at the built-in 192 kbps rate would be 192,000 x 720 / 8 = 17.3 MB, but it would take about 12 minutes to produce because compressed output is recorded in real time.

Result: The 12-minute memo becomes a WAV of about 60.6 MiB mono or 131.8 MiB stereo, ready for the editor. Choosing Opus instead gives roughly a 17 MB file after about 12 minutes of real-time recording.

How to use Audio Converter

  1. Choose an audio file
  2. Pick WAV, or WebM/OGG if your browser offers them
  3. Wait while the file is decoded and re-encoded
  4. Download the converted file

Common mistakes

Selecting WebM or OGG for a long file and then wondering why the export takes as long as the recording. Compressed output is re-recorded through MediaRecorder in real time, so 12 minutes of audio costs about 12 minutes of encoding.

Choose WAV when the destination accepts it, because the PCM writer runs faster than real time with chunked writes, and reserve Opus for cases where the smaller file justifies the wait.

Looking for MP3, M4A, AAC or FLAC in the output list. No browser API used here encodes those, so only WAV and, where supported, WebM/OGG Opus can be produced, and the code never renames the original bytes into a format it did not write.

For MP3 or FLAC, use a desktop encoder such as FFmpeg or Audacity with LAME or libFLAC, or an online service that encodes on its own server, accepting that the upload sends the recording to a third party.

Feeding in a two-hour lecture recording and expecting it to finish. The source limits are 30 minutes and 80 MB, with a warning from 10 minutes or 20 MB.

Split the recording before converting. The WAV writer also refuses output beyond about 300 MB, which a 44.1 kHz stereo 16-bit export reaches at roughly 29 minutes 43 seconds, so a stereo file just under the 30-minute cap can still be rejected.

Expecting quality to improve when a lossy source is converted to WAV. A 96 kbps MP3 written out as WAV is a large file carrying exactly the detail that was already lost.

Treat WAV as editing headroom rather than repair, and keep the original lossy file as well, since it sounds the same and is a fraction of the size.

Features

Limits worth knowing

When this is not the right tool

Frequently asked questions

Formats?

WAV is always produced. WebM (Opus) and OGG (Opus) are offered only when your browser can encode them. MP3, AAC/M4A, FLAC and WMA are impossible to encode in a browser, so they are not supported.

Quality?

WAV is lossless 16-bit PCM, so there is no quality setting. The Opus formats use your browser encoder with a choice of bitrate.

File size and duration limits?

Yes. The source must be under about 80 MB and under 30 minutes (you are warned above 10 minutes), because the whole file has to be decoded into memory. The WAV output is also capped at about 300 MB.

Privacy?

Processed entirely on your device. Your audio is never uploaded to a server.

Related tools in Converters

Further reading

Audio Converter: Convert Audio Files in Your Browser

Convert audio to WAV, or to WebM/OGG Opus when your browser supports it. Runs locally in your browser — MP3, AAC and FLAC encoding is not possible in a browser.